![]() ![]() Similar to the "Experimental peaks" option above, you can toggle the display of the peaks of entries marked in the candidate list using this option. ![]() This option can also directly be adjusted using the command/button in the diffraction pattern's context menu (right-click). You can toggle the display of the experimental peaks using this option. The advantage of using this option is that you can scroll through the entries in the candidate list or match list without any 2theta-shifts/jumps in the diffraction pattern graphics. If an entry marked in the candidate list has peaks outside the range of the experimental pattern, these peaks will not be displayed. In order to limit the 2theta-range that is displayed in the diffraction pattern to the range of the experimental pattern, this option must be activated. The following (display-) options can be set: If you enable the checkbox "Save as defaults" in the left bottom corner of the dialog, the same graphics option settings will be used next time you run Match! ![]() However, there is also a shortcut to the "Graphics" page by clicking the button in the main toolbar, as well as in the context menu of the diffraction pattern (which can be opened by right-clicking in the pattern graphics pane). It can be opened from the "Options" menu (or by pressing the corresponding button in the main toolbar). There is a variety of options for the diffraction pattern graphics which can be adjusted on the "Graphics" page of the "Options" dialog. ![]()
0 Comments
Leave a Reply. |